Stop It®
Pipe Repair System
The STOP IT® Pipe Repair System includes a strong fiberglass knitted tape, precoated with fast-setting water-activated urethane resins, and FIX STIX™, a hand-moldable epoxy. It returns lines to operation in as little as 30 minutes. Under certain conditions, active leaks (about 50 psi or less) from a pinhole may be repaired without shutting down.
Works On
Any metal or plastic pipe: steel, copper, aluminum, galvanized, black iron, stainless steel, and a wide variety of polymers. Adhesion Promoter 125 (sold separately) is required for HDPE, polypropylene and PVDF, and recommended for fiberglass, PVC and ABS.
- Pressure to 400 psi
- Sustained temperatures to 250°F
- Recommended for pipes up to 36 in. diameter (contact InduMar for >18 in.)
Used For
- Routine & Emergency Leak Repair
- Hazardous Material Spill Control
- Structural Reinforcement
- Sealing Joints
- Rebuilding Thinning Wall
- Corrosion Proofing
- Abrasion Protection
- Hard-to-Reach Areas
- Underwater Repairs
- Electrical Conduit Repair
Technical Specifications
- Tensile Strength
- 24,950 psi
- Modulus
- 62,505 psi
- Flexural Yield
- 12,005 psi
- Durometer
- 63 Shore D
- Heat Resistance
- -20 to 250°F cont.
- Color
- White or Black
- Shelf Life
- 2 yrs (40–83°F)
Tested per ASTM D 3039 / D 790 / D 2240. Temporary exposures 250–500°F.
Compliance & Chemical Resistance
- US DOT
- 49CFR 192 & 195
- Tested To
- ASME PCC-2 Art. 4.1
- Potable Water
- FIX STIX™ NSF
- VOC Content
- None
Compatible with hydrocarbons, petrochemicals, fuels, organics, acids, bases, water, steam, salts and slurries. Durability may be affected by very strong acids (pH<3) or bases (pH>12).
Sealing
Reinforcement
Resistance
Resistance
Control
